David Bamforth's Portfolio

Search This Blog

Cable Cam

Posted by Anonymous on February 06, 2017

Get link
Facebook
X
Pinterest
Email
Other Apps

Get link
Facebook
X
Pinterest
Email
Other Apps

Comments

SAE welding

A few examples of welds I completed for the SAE Baja Team at Wentworth... Figure one: Mig welded Aluminum Figure 2 and 3: SAE Baja kart Tig 4130 cage welds Figure 4: Mild steel Tig weld

For this project, I had decided to build a half cage for my Porsche Cayman S. This year I began tracking and auto-crossing my car and decided I should install a roll cage in case of a rollover and as a place to mount six-point harnesses too. This is commonly done and there are many places to buy the cages, but with my previous metalworking and welding experience, I decided to build it myself. Below are two examples of existing cages that I based by design off of. I also referenced the PCA handbook to make sure it would pass their tech inspection. After getting a plan in my head I began maying the first parts. This was the strut tower mounts seen below. While getting in and out of the car I took the rear bumper off and masked to make sure I did not damage anything. Below is one of the finished mounts with the strut bar that went between the struts. Here is the beginning of the cross brace and at the bottom, you can see the strut brace...

Dirt Road Erosion Project

This project was completed for an Intro to Engineering Design class. My classmate and I tackled the problem of erosion on dirt roads. We developed this concrete lattice that could be put into the road in high wear areas like turns and breaking areas. This was a several month long project where we went to the field to research the issue and designed and built a prototype.

Powered by Blogger

Cable Cam

Comments

Post a Comment